Tilt Protection Anti Tilt Switch Quick Response Universal For Water Heaters Easy Install

Product Description

Tilt Protection Function Anti-Tilt Switch Quick Response Universal For Water Heaters Easy Installation

Product Overview
This galvanized bracket anti-tilt safety cut-off switch is a mandatory safety spare part for wall-mounted tankless gas water heaters. It relies on internal rolling steel ball to judge the placement angle of the whole machine. When the water heater is accidentally knocked over, inclined or falls off the wall, the steel ball rolls to disconnect the internal circuit, cutting off the ignition power supply and gas supply synchronously, so as to avoid gas leakage, combustion out of control and fire accidents. Equipped with anti-rust integrated galvanized mounting bracket and heat-resistant plastic shell, it perfectly adapts to the humid high-temperature environment inside the water heater, widely used as aftermarket replacement spare part for failed original tilt switches of household and RV gas water heaters.

Main Advantages
Critical Anti-tilt Fire Prevention Safety Lock
Real-time monitor machine placement angle, cut off gas within milliseconds once tilting over limit, eliminate flammable gas leakage safety hazard.

Stable Long-life Ball Induction Structure
Hard steel ball with smooth rolling surface, thousands of tilt reset cycles without jamming or induction failure, low long-term failure rate.

Anti-corrosion Integrated Fixed Frame
Whole zinc plating treatment of metal bracket blocks steam corrosion, solve the rust and loose problem of iron brackets in old water heaters.

Heat Resistant Insulated Outer Shell
High toughness ABS plastic insulate internal metal contacts from heat radiation, extend service life of induction assembly.

One-step Quick Replacement Installation
Built-in metal mounting lug with reserved screw hole, just lock the bracket inside the water heater with one small screw to finish fixing.

Wide Universal Compatibility
Suitable for natural gas and LPG 12L~16L household and RV tankless gas water heater models.

Installation Tips
Fix the switch bracket vertically on the inner plate of the water heater according to the factory installation direction to ensure normal tilt induction.

Wire the switch in series into the ignition circuit of the main control board strictly following wiring diagram.

Do not scratch the galvanized coating of the metal bracket during installation to retain anti-rust performance.

Replace the whole tilt switch assembly immediately if the plastic shell cracks or the ball contact fails to cut off circuit.

FAQ:
What is the function of the Water Heater Anti-Tip Protection Switch?
Answer: It is a safety protection component for water heaters (especially gas water heaters). When the water heater tilts beyond a safe angle (usually 30-45 degrees), it will automatically cut off the gas and power supply to prevent gas leakage, fire or other safety hazards caused by tipping.

How does the Water Heater Anti-Tip Protection Switch work?
Answer: It is equipped with an internal gravity sensor or mechanical trigger. When the water heater tilts, the internal sensor or trigger moves, triggering the switch to disconnect the gas and power circuits, realizing automatic shutdown protection.

Is the Anti-Tip Protection Switch a mandatory component for water heaters?
Answer: Yes, For gas water heaters, it is a mandatory safety component specified by national standards, which must be installed to ensure the safety of use; most electric water heaters also have this component to prevent tipping damage.

Why does the Water Heater Anti-Tip Protection Switch trigger accidentally?
Answer: The water heater is not installed stably, the installation surface is uneven, external collision causes slight tilting, or the switch’s sensitivity is too high.

What should I do if the Anti-Tip Protection Switch is triggered accidentally?
Answer: First, turn off the water heater’s gas and power supply, adjust the water heater to a horizontal and stable position, check whether the switch is reset, then turn on the power and gas again to test whether it works normally.